on way - Jens
About the Lilygo ESP32 S3 T-Display board pipnout
Boot button is connected to GPIO0
Other button to GPIO14 (as seen on image)
 |
Schematics
See here
ESP32 S3 duo core 240MHz
1.9" 170x240 pixels OLED color
16 MB Flash, 8 MB PSRAM
On image below upper left is 0,0 and lower right is 134,239
Uses ST7789V chip as OLED driver ( same as TTGO T1)cp /Des
important to knwo when we are going to configure graphichal driver
Pin info
IMGINCL
THE BEER-WARE LICENSE (Revision v 42)
jensd@jensd.dk wrote this file.
As long as you retain this notice you can do whatever you want with this stuff on these pages.
If we meet some day, and you think this stuff is worth it, you can buy me a beer in return :-)
(C) Jens Dalsgaard Nielsen
credit for license this goes to phk@FreeBSD.ORG
As long as you retain this notice you can do whatever you want with this stuff on these pages.
If we meet some day, and you think this stuff is worth it, you can buy me a beer in return :-)
(C) Jens Dalsgaard Nielsen
credit for license this goes to phk@FreeBSD.ORG